|Date Added:||28 June 2017|
|File Size:||29.5 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
See your browser’s documentation for specific instructions. Make sure the plotter’s serial port settings are set to the factory defaults. Apparently he used it back len the day for printing circuit layouts which were photo-reduced and etched onto silicon. Asia Pacific and Oceania.
The following procedures also apply to drafting pens and carousels.
The wiring for pin to 9-pin cables listed above are identical. If used alone, pressing one of the buttons causes the plotter to store its current pen if it has one and to select the pen number whose button was pressed.
HP Computer Museum
The rear input panel. This will set the computer’s RSC serial port for baud, no parity, 8 data bits, one stop bit, and specify hardwire handshake with continuous retry. A straight through serial cable will not work properly. When the plotter is plotting, the view function is not performed until the plotter completes the current vector.
Rotate the carousel slightly until it drops into position on the spindle. In step 1 verify that a black pen is installed in stall 8 of the carousel. This provides space for the wide digitizing tip and permits the plunger to retract fully and seat properly in the plotter.
Pull the plunger down again and release it to assure that the cap seals without binding. Please note this form is for feedback only, so you will not receive ;lotter response. You get a sense for that at the end of this video: Set the port parameters to match the plotter default settings i. Information This document discusses the front panel controls buttons and indicators on the HP B, B, and B Drafting plotters. Now select Properties and then select the Details tab.
Refer to Operating States. Loading the Digitizing Site. Larger amounts 77585b information may reveal this type of problem. If no positions are empty, the pen store request is ignored. In Windows, select Start, Settings, Printers. This configuration sets the plotter for the following: If there is a pen in the pen holder, but there are no empty positions in the carousel for storing the pen, the pen select request is ignored.
Europe, Middle East, Africa. The display is used when setting pen speed or pen force from the front panel.
HP 7580B, 7585B, and 7586B Plotters – Loading Pens, Carousels, and Digitizing Site
Refer to Appendix A for descriptions of the self-test errors.